I supplement 2 nstructions for the preparation of papers

I Supplement 2 NSTRUCTIONS FOR THE PREPARATION OF PAPERS FOR PUBLICATION IN PROCEEDINGS OF THE CONFERENCE«POWER ELECTRONICS AND ENERGY EFFICIENCY» СЭЭ’2008A.B. IvanovDepartment of Industrial and Biomedical Electronics National Technical University “Kharkov Polytechnical Institute”21 Frunze Str., Kharkov, 61002, UkrainePhone/fax: (+38 057) 707-6312, E-mail: ivanov@kpi.kharkov.uaAnnotation – Instructions for the preparation of papers for publication in proceedings of the conference are given in these materials.Key words – papers, proceedings, conference.INTRODUCTIONThe paper for the conference should be prepared using Word for Windows processor. The full text should contain 4 or 6 pages and be printed in laser quality (300 dots/in or better) on a high quality white sheets paper of A4 format (297  210 mm) with 80 – 90 g/m2density.^ RECOMMENDATIONS FOR AUTHORSThe main text should be typed using Times New Roman 10 pt font, left and right justified, with single spacing in two columns with 5 mm gap. Columns of the last page must be filled for not less than 85 % and have equal length. The first line of each paragraph should be indented by 7 mm. Page setup is given in Table 1.Table 1 Left margin 15 mm Right margin 24 mm Top margin 21.2 mm Bottom margin 21.2 mm For title of the paper 12 pt bold font, centered, should be used. The title must have no hyphenations. Leave single spacing after the title (12 pt) and give information about the author(s) by 10 pt font as shown above.Then, after single spacing (10 pt), place annotation (about 50 words) and after single spacing again - key words (up to 5), using 9 pt bold font. The words Annotation and Key words must be typed in Italic.The main text may be divided on chapters. In this case leave 10 pt spacing between the heading and the text. Do not number the chapters.The headings are typed by 10 pt font, centered, capital.Equations should be centered and numbered:. (1)Large equations should be typed in several lines: Please, provide tables and figures not wider than one column. Tables or figures with width of two columns may be placed on top of the second and the following pages. Figure captions are typed by 9 pt font.Fig. 1CONCLUSIONUse (1), (1) and (2) for equations; Fig. 1, Fig. 1 and 2 for figures; Table 1, Table 1 and 2 for tables; [1], [1-3] for references.References should be presented at the end of the paper with single spacing 10 pt after the main text:[1] P.B. Johns, A symmetrical condensed node for the TLM method, IEEE Trans. Microware Theory Tech., vol. MTT-35, pp. 370-377, Apr. 1997.[2] C. Christopoulos, The transmission-Line Modelling Method. Piscataway, NJ: IEEE Press, 1995.